1993 grand am water pump

I'm doing a water pump on a 1993 Grand Am with the 3.3 liter motor and I can't get the pulley for the water pump off I have the four bolts out that connect the pulley to the water pump and I read that you have to have the water pump out to get the pulley off to put on the new one, but the pulley is blocking the bolts to get the water pump out! Also I can't get this cast iron piece out that goes to the motor mount because the pulley is blocking the removel of one bolt! Please help!

Welcome to AF Travis !

You can use some WD40 around the center of the pully.
Then lightly tap around the pully, it should pop off, they get a little crusty and stick pretty good sometimes. Might pry lightly , carefull not to break anything while prying.

1993 grand am water pump Copyright Disclaimer:
Contents of this page are from the Internet, the copyright belongs to the original page. All actions are under your responsability, please delete them after 24 hours or purchase it. Email us to report illegal contents.

1. '96 V6 SE fuel gauge, speedometer, tachometer not working. HELP!
2. Low speed fan
3. 2000 Grand Am GT, misc annoying PS and electrical problems
4. what a nightmare where is flasher 94 GA
5. '94 LED turn signal problem
6. 97 Gr Am - coolant leak, no overheating
7. 2005 Grand Am headlight/turn single wiring problem
8. Turning GT taillights into Clear for non-GT Plz Help
9. 97 GA keyless entry swap
10. obd 2 codes and how to fix them
11. '94 SE tail light removal
12. '94 SE License Plate Bracket
13. 97 gt stereo vs stereo with sterring controls
14. 99 fuel pump???
15. 02 Grand Am Trans? Sensor?

No comments for "1993 grand am water pump ".