1999 Jeep Grand Cherokee

How in the world do you remove the dash to replace a heater core???
We have removed every bolt that we can possible think of, but the dash still won't budge- it is loose
It seems that a mystery bolt is holding the dash from removal
Anybody??? Any suggestions???

DId you remove the bolts in the center (bolted to the tranny hump)?

unfortunately--yes I have unbolted the tranny hump bolts
even Alldata is stumped
pages and pages of stuff I have already done

Did you get the nut that is up above the brake pedal?The dash also clips in at the sides and you kind of have to lift and pull at the same time.

This should help.
http://www.wjjeeps.com/hvac_ip_remove.htm

got that one too.
when I try to pull the dash forward, it seems to be hung up in the center area of the dash, like behind the radio area
both sides of the dash seem ready to come out, but the center area is still attached to something

is it still clipped to the defroster ducts?

1999 Jeep Grand Cherokee Copyright Disclaimer:
Contents of this page are from the Internet, the copyright belongs to the original page. All actions are under your responsability, please delete them after 24 hours or purchase it. Email us to report illegal contents.

1. Help with slight engine knock
2. Sputters under load~
3. please HELP me 97 jeep multiple misfire on cyl #'s 5 6 and 8
4. Thumping sound in front when coasting
5. 1997 Grand Cherokee V8 4WD
6. Brake Booster - 1999 Grand Cherokee Limited
7. Transmission Question...
8. Possible warranty extension '96-'99 Please read
9. jeep slow to shift into reverse
10. 1997 Grand cherokee limited 5.2 starter?
11. Occasional rough run, crazy tach, no start
12. selec-trac problem
13. Valve train noise.
14. over drive light
15. fuel odors

No comments for "1999 Jeep Grand Cherokee ".