86 GT Header problem

Hey all,
I just installed a set of MAC 1 5/8 ceramic unequal shorties on my otherwise original, 79,000-mile 1986 GT 5.0 AOD. Everything fit fine except this: The u-joint on the steering shaft rubs the rear header tube. The car sits sort-of low, so I installed offset steering rack bushings yesterday hoping the u-joint would move up and clear. But the problem remains. I plan to change the motor mounts next. They might be sagging. Any ideas?
Thanks,
Dale

86 GT Header problem Copyright Disclaimer:
Contents of this page are from the Internet, the copyright belongs to the original page. All actions are under your responsability, please delete them after 24 hours or purchase it. Email us to report illegal contents.

1. po420
2. 95 mustang gt stalls while driving
3. My diagnostic tools for my Ford car
4. transmission vibrating
5. help with starting
6. 1990 Mustang LX 5.0L Ball Joints
7. 2000 mustang 5 speed parts car. 2500
8. 2004 40th aniversary edition.. .
9. My Next upgrade?
10. performance chip or programmer
11. reverse gone when warm
12. 88 mustang gt rear drum swap for disc brakes?
13. No headlights
14. blinkers 91.5.0
15. struts or shocks ???

No comments for "86 GT Header problem ".