to hot!

i have my MTX 902 2 channel amp powering 2 10 in alpine type r's, I have it wired series/parallel and for some reason its not powering them very well unless i have the gain up most of the way and the amp gets to hot to touch and it shuts off, i belive because of the heat, oh and i have 0 ga coming from the battery into a dist block that runs a 4 gauge wire to the amp. the amp accepts 0ga, could to small a wire be whats causen it to get to hot? help! =(

Re-check your wiring and see if you are running it at the specified impedence. Chances are, your impedence is lower than the amp can handle, and cause it to burn up.

Make sure you have tight connections, expecially the ground wire/s!

to hot! Copyright Disclaimer:
Contents of this page are from the Internet, the copyright belongs to the original page. All actions are under your responsability, please delete them after 24 hours or purchase it. Email us to report illegal contents.

1. Annual Spring MD/VA/DC/PA EURO Meet, Drive & Dine [Sunday, June 1st]
2. '76 Chevy C10 - Having Problems At Startup
3. Classic Dodge Charger with Supra engine
4. All Make And Model Car And Bike Show June 7th
5. Audi S2 vs. Suzuki GSX-R 1000
6. Car buying help!
7. Does This Dealer Make Sense?!
8. new product Autocern
9. Dirt Bike Crashes Into Wall
10. Mercedes 190E 2.3-16 turbo doing 10s on qm
11. Safest most reliable sedans
12. Lost Here!!!
13. Porsche Carrera GT - MotorWeek
14. Teaching Aids with Cutaway.
15. Nissan Z history

No comments for "to hot! ".